T1 11 window install4/11/2024 ![]() It can be painted, stained, cut, and arranged in different ways to create a variety of looks. They are often used to make a shiplap or rustic board-and-batten look on a home exterior. T1-11 siding, also known as OSB siding or T1-11 siding, is a type of plywood panel. The natural wood-grained look made it a popular siding choice at the time. If your home was built in the 60’s, 70’s, or early 80’s, it’s likely to have T1-11 siding. How to Know if Your Home Has T1-11 siding There are, however, some steps you can take to help prevent damage to your home until your siding is able to be replaced with a more durable siding. Unfortunately, T1-11 siding doesn’t stand up too well to the elements, and over time will begin to deteriorate, opening your home up to damage from water, pests, and a host of other problems. You should be able to click on the photo for a larger view.Advertised as T1-11 or T-111 siding, this common siding has been used for decades on homes due to its low cost and its fast and easy installation. Here is the panel progress at the front wall. The panels have a tongue and groove (T&G) sides so they overlap for a tight fit. Start at one wall corner and install panel by panel as you work along the wall. I opted for galvanized 8d common nails for bit more strength and used that same nailing pattern. ![]() We were required, at a minimum, to use 6d nails at 6 inch on center along all panel edges and at 12 inches on center along wall studs at the panel interior. Let’s get these panels up! Since they are structural, you need to be mindful of type and spacing of the nails. This adds just a little extra rot protection and peace of mind. I like to put one coat of primer on the panels and along all the edges before installing them. A hand saw comes in handy to finish off the interior corners. Then I cut the panels with a circular saw. I use a measuring tape, a pencil, and a speed square with a level butted up against it to extend straight lines. ![]() The panel behind me is cut for the first window opening. There were a few tricky ones where I did call in a second set of hands for help. I wanted to show a picture of my self here to show that really any relatively fit person can do this! As you can see, I’m not a huge burly construction worker, but I make it work and installed most of these panels myself. Here I am at my panel processing station where I prepare each section. I work panel by panel and carefully measure and cut the panel openings. need to be cut before we nail the panels to the wall. As of this writing, each 19/32 inch thick x 4 ft x 8 ft panel at the local Home Depot here costs under $40.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |